Futaba S9650 Digital Mini Servo
Best to operate in 6V. Good to use for rubber servo on 450 class helicopters or to control CCPM on 500 class helicopters.
Features:
This is a High Torque, High Speed Digital Mini Servo from Futaba.
Coreless motor: conventional servo motors have a steel core armature wrapped with wire that spins inside magnets.
In a coreless design the armature uses a wire mesh that forms a cup that spins around the outside of a magnet.
This arrangement is much lighter, which results in smoother operation and faster response time.
Nylon Gears
Can be used with 1/12 or 1/18 scale vehicles and electric helicopters
Specification:
Control System: +Pulse Width Control 1520usec Neutral
Required Pulse: 3-5 Volt Peak to Peak Square Wave
Operating Voltage: 4.8-6.0 Volts
Operating Temperature Range: -20 to +60 Degree C
Operating Speed (4.8V): 0.14sec/60 degrees at no load
Operating Speed (6.0V): 0.11sec/60 degrees at no load
Stall Torque (4.8V): 50 oz/in. (3.6kg.cm)
Stall Torque (6.0V): 62.5 oz/in. (4.5kg.cm)
Operating Angle: 45 Deg. one side pulse traveling 400usec
360 Modifiable: No
Direction: Counter Clockwise/Pulse Traveling 1520-1900usec
Motor Type: Coreless Motor
Potentiometer Drive: Indirect Drive
Bearing Type: Dual Ball Bearings
Gear Type: All Nylon Gears
Connector Wire Length: 12"
Dimensions: (43 x 15 x 28.6mm)
Weight: .92oz. (26g)
Package Included:
Futaba S9650 Digital Mini Servo
4 rubber grommets and brass eyelets, and one .83" (21mm) diameter round horn
Digital servo precaution sheet
Notes:
Will NOT work with these Futaba radios (4FG, 5FG/K, 6FG, 6FG/K, 7FG/K, New Terratop, 3EGX, 3PGE, 2NL, 2LGX, 2FR, 2PK series)
These radios have a servo neutral signal of 1310us not compatible with this servo.
***For MAXIMUM performance, a 6.0V battery is recommended***
Stock/Manufacturer #FUTM0260
|
Special Offer! 
