|
Already comes with firmware version 2.2b2!
This gimbal controller supported 2-Axis brushless motors and is adjustable, so it can be balanced for camera perfectly.
The original version Brushless Gimbal Controller by Ludwig Färber (Hardware and Software) , Alexander Rehfeldt (Software) and Christian Winkler (Software). This is an Open Source Project. We add a MOSFET for reverse polarity protection and a status blue LED for status indication. When you running original firmware (e.g. 049) the LED will show you the startup status.
Hardware Features:
•2-Axis output supported
•ATMega328P microcontroller
•Onboard FT232RL USB-TTL converter
•Input reverse polarity protection
•2~6 cells lipo input
•3 Channels input
•Power and status LED
•Multiport
•UART Port
•MPU6050 6 axis gyro/accel with Motion Processing Unit (IMU board)
•On board logic level converter (IMU board)
•3.3V/500mA LDO voltage regulator (IMU board)
•Dimension: 50mmx50mm
•Height: 11mm
•45x45mm mounting holes
•Weight: 27g (include IMU board)
Package content:
•2-Axis Brushless Gimbal Controller x 1
•IMU board x1
•1.25-5Pin cable 300mm x1
Note:
-this is not the official SimpleBGC board. DO NOT upgrade firmware by yourself otherwise the board may brick!
- this product requires DIY soldering and wiring as well as software confirguration. Not for beginner.
|
Special Offer! 
