Hitec HS-82MG Metal Gear Servo
Best match for controlling your 300/450 class EP helicopters, small airplanes, gliders and 1/18 scale cars!!
HS-82MG Servo Features:
The HS-82MG is brand new and is replacing the HS-81MG. Available in both resin and metal gear versions. With a fine balance between speed and torque, the HS-82MG’s were designed to be both economical and reliable. They are perfect for small electric aircraft as well as throttle servos on gas aircraft. By utilizing the standard size Hitec spline, any horn or arm that fits on a standard Hitec servo will fit on the HS-82MG.
Servo Specifications:
|
Control System: +Pulse Width Control 1500usec Neutral
Required Pulse: 3-5 Volt Peak to Peak Square Wave
Operating Voltage: 4.8-6.0 Volts
Operating Temperature Range: -20 to +60 Degree C
Operating Speed (4.8V): 0.12sec/60° at no load
Operating Speed (6.0V): 0.10sec/60° at no load
Stall Torque (4.8V): 38.8 oz/in. (2.8kg.cm)
Stall Torque (6.0V): 47.2 oz/in. (3.4kg.cm)
Operating Angle: 40 Deg. one side pulse traveling 400usec
360 Modifiable: No
Direction: Clockwise/Pulse Traveling 1500 to 1900usec
Current Drain (4.8V): 8.8mA/idle and 220mA no load operating
Current Drain (6.0V): 9.1mA/idle and 280mA no load operating
Dead Band Width: 8usec
Motor Type: 3 Pole Ferrite
Potentiometer Drive: Direct Drive
Bearing Type: None, outer case serves as bearing
Gear Type: 4 Metal and 1 Nylon
Connector Wire Length: 6.29" (160mm)
Dimensions: 1.17" x 0.47"x 1.16" (29.8 x 12 x 29.6mm)
Weight: 0.66oz (19g)
|
|
| |
This servo can operate 180° when given a pulse signal ranging from 600usec to 2400usec.
Package Included:
- 1 x Hitec HS-82MG Micro Servo
- 1 x Servo mounting screws
- 1 x Two-sided servo horn
- 1 x One-sided servo horn
- 1 x M1.7x3 servo horn screw
- 1 x Four-sided servo horn
- 1 x Instruction Sheet
Stock/Manufacturer # 32082S
|
Helicopters 
