Aileron Carbon Fiber Linkage Rod Set for Align T-Rex 700E
●Use for T-REX 700E
Specification:
●700E Linkage x 4(2x110mm)
●700E Aileron Control rod Carbon Fiber Shaft x 8(4x5.4x6.5mm)
●700E Aileron Control rod Carbon Fiber Tube x 4(2.2x3.9x96mm)
●700N Ball Link x 8(5x20.5mm)
| Illustration 1:Mix thoroughly suitable amount of epoxy. |
Illustration 2:Apply generous amount of epoxy on the tips of carbon tube after sliding over the linkage rod.
(Note: for quick drying epoxy, work fast as it must be applied prior to curing) |
|
|
|
| Illustration 3:Slide the carbon end caps on both sides of the carbon tube. |
Illustration 4:Thread the ball links onto the linkage rod until the base to base length is 97.5mm. |
|
|
|
| Illustration 5:If gap exists between the ball link and end caps after correct length has been achieved, slide the end caps outwards to cover the gaps (note: must be done before epoxy cures) |
Illustration 6:Wipe away excess epoxy and set it aside to cure. |
|
|
|
| Illustration 7:Pop the finished link back between aileron servo horn and bell crank. |
|
|
|
Note:
- due to the unstable supply of Align products, if we cannot supply you this product in a short period of time, we will ship out the other items in your order first and refund you the amount of the unavailable items or ship later.
- please mark in the comment during checkout if you want your order to ship only in full, or tell us the model # of the spare parts you need urgently.
- unavailable Align spare parts usually can be restock in 1-2 weeks.
|
Helicopters 
